NPM Biofuel Maintenance Station
HOME > Support Tips

There are some regular maintenance we should keep doing for lengthening the lifespan of the pellet mill machines.

  1. Check the condition of the electric control gear every month;
  2. Check to see if the electric wire is aging or not every month; (more…)
Malfunction 1: low productivity
Cause:
The flat die has coarse finish for first time using
The moisture content of the raw material is too high or too low (no more than 20%)
The gap between the roller and die too large
The roller or die has severe wear (more…)

Add oil to the transmission parts at regular time, add lubricating oil to pressure roller every two hours, add lubricating oil to front bearing ofmain shaft every four hours, ensuring transmission parts of pellet mill run flexibly and reducing workload.

Change the lubricating oil of gear case at regular time. For new pellet mills, change oil after half a month of operation;change oil after every 1000 hours of continual operation, which can lengthen the lifespan of gear case.

(more…)

1Firstly,it is necessary to do a general check to tighten any loose button once you have bought a new pellet mill in order to ensure that the machine is secure to run. Don’t forget to set the running direction of the machine according to the direction mark before opening.
(more…)

If you have any questions related to the maintenance of NPM pellet mills, please submit below and we will contact you as soon as possible.